Revolver ordering information
for the Aluminator-2

	The Aluminator-2 will work fine with most S&W and Taurus medium and large frame revolvers. We need to know the following dimension as no two revolvers are the same. There is no extra charge for cutting the LockBlok to suit your revolver if requested at time of ordering.
	We also need to know the following dimension as you may require a longer support rod. There is no extra charge for the longer support rod to suit the barrel length of your revolver or semi-auto if requested at time of ordering.
	This picture shows a S&W with a 4" barrel and a trigger-guard to muzzle length of about 4-3/4" which will easily fit the standard rod length. If this dimension on YOUR gun is GREATER than 6-1/4" then you will need to order a longer rod. To calculate the new length, use the dimension you get on your gun, minus 6-1/4" and add it to 8-1/4" (the length of a standard rod). For example, let's say your gun measured 8-3/4". Subtract 6-1/4" and this gives you 2-1/2". Add this to the standard rod length of 8-1/4 and you get a rod length of 10-3/4". This is what you would order. You can always order an even longer rod and cut it to suit.
	All graphics and contents of this web-site are the exclusive Copyright of Nolan Innovation Inc. 1998